RELEASED TO CARRIER JUNE 25 has been entered. Since this is a trailer
should also include in this section, the tariff rate quoted for the
this is 1008F. The container weight, in the column headed Container or
Weight, should be 15,450.
The next column should be blank.
Gross Weight is the container weight plus the Total Weight of the
(15,450 + 11,470 = 26,920). The GBL Number should be NP000002. This
your review of the worksheet for SHPT A.
SPWS (SECTION 1)(SHIPMENT B)
Now you must review SHPT B on the SPWS. This data is taken from DD Form 1348-1A
(see Figure 2-15). Beginning with Line 1 of Section I, SHPT B should be entered
The Document Number is taken from Block 14 at the
in the first two columns.
bottom of DA Form 1348-1A. The Supply Pack is from Block H. Total Pack is found
in Block Q. Total Weight is from Block I, and Total Cube is found in Block J.
The RDD is found in the upper row under the same heading. Trans Priority is in
the same row next to the RDD.
Ensure that these items are entered in the
appropriate spaces on the SPWS (see Figure 2-16). The next two columns should be
The Original AAC is from Block A as is the Origin in the Clear Name.
Both of these should be entered, as well as the Origin in the Geographical
Location. The Destination AAC and Destination in the Clear Name is from Block B.
Ensure that your personnel wrote these in the appropriate columns.
Now go to Line 2 (see Figure 2-17). Nomenclature is from Block X of DA 1348-1A.
The Commercial Name should be entered here--ammunition, cartridges, and small
arms loaded in boxes. The MILSTAMP Name is found in Block U. The Item Number is
5980. The mode should again be V because the shipment will be sent by surface.
According to the NMFC, the TL Min. Wt. should be 36,000 LBS, the $ Rate for SHPT
B should be 795.60, and the Reference Pub. should be the NMFC. (We have already
looked up this information in the NMFC.)
Now proceed to Line 3.
According to DOD Reg 4500.32-R, Volume II, the True
Shipping Name is listed as the 214th AVN CO; the AMMO DODIC as C237; Net
Explosive Weight as 1068; Ammunition Rounds and Lot No. as 2000 and MA264; and
the Dot Class as "C." Ensure that these entries are all written in the
appropriate columns. The next two columns should be blank. The Remarks column
should contain the Federal Stock Number (FSN). This completes Section I of the
SPWS for shipment B.